SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1181 (CELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEM)REPAIR INSTRUCTIONSRADIO SPEAKER AMPLIFIER REPLACEMENT (EXCEPT CADILLAC)
2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A

Radio Speaker Amplifier Replacement (Except Cadillac)

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Radio Speaker Amplifier Replacement (Except Cadillac)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Radio Speaker Amplifier Assembly & Components
GM1696529Courtesy of GENERAL MOTORS CORP.
Callout Component Name
1 Front Floor Console Screw (Qty: 8)
NOTE: Refer to Fastener Notice .

Tighten:  9 N.m (80 lb in)
2 Front Floor Console Assembly
Refer to Front Floor Console Replacement (Except Cadillac) or Front Floor Console Replacement (Cadillac) .
3 Front Floor Console Bracket Screw (Qty: 4)

Tighten:  9 N.m (80 lb in)
4 Front Floor Console Bracket
5 Amplifier Screw (Qty: 3)

Tighten:  9 N.m (80 lb in)
6 Radio Speaker Amplifier Assembly
Tip: 
  • Disconnect the electrical connectors.
  • If installing a replacement amplifier, program the amplifier. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.