Front Seat Back Frame Replacement

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Front Seat Back Frame Replacement
WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Seat Back Frame Replacement
GM1969556Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the front seat. Refer to Front Seat Replacement - BucketΒ .
  2. Remove the front seat back cushion cover and pad. Refer to Front Seat Back Cushion Cover and Cushion Pad ReplacementΒ .
1 Front Seat Back Cushion Frame Bolt (Qty: 4)
NOTE: Refer to Fastener Notice .

Tighten:Β  50 N.m (37 lb ft)

2 Front Seat Back Cushion Frame

Procedure

  1. Disconnect electrical connectors as needed.
  2. If replacing with a new front seat back frame, transfer components as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.