Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2012CHEVY EXPRESS G2500, VAN PASSENGER, 4.8L ENG VIN AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1028 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSREAR OBJECT SENSOR REPLACEMENTREMOVAL PROCEDURE

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN A

Removal Procedure

2012 Chevrolet Chevy Express G2500, Van Passenger, 4.8L Eng VIN ASECTION Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Object Sensor

Courtesy of GENERAL MOTORS CORP.

Disconnect electrical from the rear object sensor.
Lift the locking tabs on the housing and remove the rear object sensor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.