SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CAMARO LS, STANDARD TRANSREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A6C THROUGH K20 X2 (LSA)COMPONENT CONNECTOR END VIEWSK9 BODY CONTROL MODULE X7
2012 Chevrolet Camaro LS, Standard Trans

K9 Body Control Module X7

2012 Chevrolet Camaro LS, Standard TransSECTION K9 Body Control Module X7
GM2282920Courtesy of
Connector Part Information
  • Harness Type: Instrument Panel
  • OEM Connector: 13594132
  • Service Connector: 19151265
  • Description: 26-Way F 0.64 2.8 Series (GY)
Terminal Part Information
  • Pins: 1, 3
  • Terminated Lead: 13575560
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-35 (VT)
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: E/A
  • Pins: 6, 7, 9, 13, 15, 19
  • Terminated Lead: 13575870
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
K9 Body Control Module X7

Pin Wire Circuit Function
1 0.5 GY 157 Courtesy Lamp Control
2 - - Not Used
3 0.5 L-GN 24 Backup Lamp Supply Voltage
4-5 - - Not Used
6 0.35 TN 7553 Automatic Transmission Shift Lock Control Solenoid Control (MYB/MYC)
7 0.5 OG/BK 737 Rear Compartment Lamp Control
8 - - Not Used
9 0.5 YE 6817 LED Backlight Dimming Control
10-12 - - Not Used
13 0.5 PU 5357 Right Tail Lamp Outage Detection Signal (T90)
14-18 - - Not Used
19 0.35 WH 156 Courtesy Lamp Switch Signal
20-26 - - Not Used
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.