SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CAMARO LS, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROLS/FUEL - 3.6L - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSFUEL LINE REPLACEMENT - CHASSISREMOVAL PROCEDURE
2012 Chevrolet Camaro LS, Automatic Trans

Removal Procedure

2012 Chevrolet Camaro LS, Automatic TransSECTION Removal Procedure
    Fig 1: Fuel Feed Connector, Evaporative Emission Connector, Exhaust Heat Shield & Fasteners
    GM2194736Courtesy of GENERAL MOTORS COMPANY
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .
  2. Disconnect the fuel feed connector (1) and the evaporative emission connector (2). Refer to Metal Collar Quick Connect Fitting Service , and Plastic Collar Quick Connect Fitting Service .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the exhaust heat shield fasteners (3) and the exhaust heat shield (4).
    5. Fig 2: Exhaust Heat Shield Fastener & Exhaust Heat Shield
    GM2194739Courtesy of GENERAL MOTORS COMPANY
  5. Remove the exhaust heat shield fastener (1) and the exhaust heat shield (2).
    6. Fig 3: Brake Pipe Heat Shield Fastener & Heat Shield
    GM2194740Courtesy of GENERAL MOTORS COMPANY
  6. Remove the brake pipe heat shield fastener (1) and the heat shield (2).
    7. Fig 4: Plastic Retainer & Retaining Nut
    GM2194746Courtesy of GENERAL MOTORS COMPANY
  7. Remove the plastic retainer (1) and the retaining nut (2).
    8. Fig 5: Fuel Feed Line & Evaporative Emission Line Clips
    GM2194747Courtesy of GENERAL MOTORS COMPANY
  8. Separate the fuel feed line and the evaporative emission line from the clips (1).
    9. Fig 6: Protector Bracket Fasteners & Bracket
    GM2194773Courtesy of GENERAL MOTORS COMPANY
  9. Remove the protector bracket fasteners (1) and remove the bracket (2).
    10. Fig 7: Fuel Feed Line & Evaporative Emission Line
    GM2194775Courtesy of GENERAL MOTORS COMPANY
  10. Disconnect the fuel feed line (1) and the evaporative emission line (2). Refer to Metal Collar Quick Connect Fitting Service , and Plastic Collar Quick Connect Fitting Service .
  11. Remove the pipes (3) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.