SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 815 (TRANSFER CASE - NVG 246-NP8)REPAIR INSTRUCTIONSTRANSFER CASE SHIFT CONTROL SWITCH REPLACEMENT
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Transfer Case Shift Control Switch Replacement

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Transfer Case Shift Control Switch Replacement
WARNING: This page is about a different car, the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transfer Case Control Switch
GM1696845Courtesy of GENERAL MOTORS CORP.
Transfer Case Shift Control Switch Replacement

Callout Component Name
Preliminary Procedure: 
Remove the headlight bezel. Refer to Headlamp Switch Bezel Replacement .
1 Switch, Transfer Case Control
Tip: 
  • Disconnect the electrical connectors from the headlight and control switches.
  • It may be necessary to use a small flat bladed screw driver to depress the locking tabs to remove the control switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.