SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 490 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSBLOWER MOTOR REPLACEMENTINSTALLATION PROCEDURE
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Installation Procedure

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Blower Motor To HVAC Module
    G01418701Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor to the HVAC module.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the blower motor retaining screws.

    Tighten 

    Tighten the screws to 1.7 N.m (15 lb in).

  3. Connect the blower motor cooling tube to the HVAC module.
  4. Connect the blower motor electrical connector.
    Fig 2: Connecting Blower Motor Electrical Connector
    G01418702Courtesy of GENERAL MOTORS CORP.
  5. Install the I/P lower insulator panel - RH. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Instrument Panel, Gages and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.