SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1899 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEW 4 OF 5)REARVIEW CAMERA IMAGE DISPLAY MODULE (UVC)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Rearview Camera Image Display Module (UVC)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Rearview Camera Image Display Module (UVC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rearview Camera Image Display Module (UVC) Connector End View
GM1710983Courtesy of GENERAL MOTORS CORP.
Rearview Camera Image Display Module (UVC)

Pin Wire Color Circuit Function
1 0.35 D-BU 38 Backup Lamp Control
2 0.35 PK 239 Ignition Voltage
3 0.35 BK/WH 2751 Ground
4 0.35 OG 6201 6-Volt Reference
5 0.35 TN/BK 6202 Camera Ground
6 - - Not Used
7 0.35 BARE 6974 Camera Drain Wire
8 - - Not Used
9 0.35 WH 6798 Camera Video Signal
10 0.35 BARE 6799 Camera Shield
11 0.35 L-BU 6973 Camera Signal -
12 0.35 PK 6972 Camera Signal +
Connector Part Information 
  • OEM: 15499371
  • Service: 19115105
  • Description: 12-Way F KAIZEN 0.64 (BK)
Terminal Part Information 
  • Terminal/Tray: 7116-4618-02/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215A/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.