SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1896 (COMPONENT CONNECTOR END VIEW (1 OF 5))BODY CONTROL MODULE (BCM) X6
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Body Control Module (BCM) X6

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Body Control Module (BCM) X6
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Body Control Module (BCM) X6 Connector End View
GM1664502Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X6

Pin Wire Color Circuit Function
1 - - Not Used
2 1 L-BU 20 Stop Lamp Control
3-11 - - Not Used
12 0.35 PK/BK 1303 Liftgate Ajar Switch Signal (E52 without E61)
13 0.35 GY 5797 Rear Closure Handle Switch Open Signal (E52 without E61)
14 0.35 L-GN/BK 748 Right Rear Door Ajar Switch Signal
15 0.35 L-BU/BK 747 Left Rear Door Ajar Switch Signal
16 0.35 OG 5922 Non-Driver Door Open Switch Signal
17-23 - - Not Used
24 0.35 PK 6190 Lift Glass/Trunk Exterior Release Signal (E52 without E61, except HP2)
25 - - Not Used
Connector Part Information 
  • OEM: 15482793
  • Service: 88988842
  • Description: 25-Way F HIT Series (PK)
Terminal Part Information 
  • Pins: 1-5
  • Terminal/Tray: SNAC-A061T-M2.8/20
  • Core/Insulation Crimp: C/A
  • Release Tool/Test Probe: 12094429/J-35616-4A (PU)
  • Pins: 6-25
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
  • Release Tool/Test Probe: 15315247/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.