SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MODE ACTUATOR THROUGH YAW SENSORCOMPONENT CONNECTOR END VIEWSVEHICLE COMMUNICATION INTERFACE MODULE (VCIM) X2 (UE1)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Vehicle Communication Interface Module (VCIM) X2 (UE1)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Vehicle Communication Interface Module (VCIM) X2 (UE1)
Fig 1: Vehicle Communication Interface Module (VCIM) X2 (UE1) Connector End View
GM1471691Courtesy of GENERAL MOTORS CORP.
Vehicle Communication Interface Module (VCIM) X2 (UE1)

Pin Wire Circuit Function
1 0.35 D-BU 658 Cellular Telephone Voice Signal
2 0.35 L-BU/BK 659 Low Reference
3 0.5 TN/BK 2500 High Speed GMLAN Serial Data Bus+
4 0.5 TN 2501 High Speed GMLAN Serial Data Bus-
5-7 - - Not Used
8 0.5 BARE 1782 Drain Wire (HP2)
0.35 BARE 1782 Drain Wire (except HP2)
9 0.35 GY 655 Cellular Microphone Signal
10 0.5 BARE 514 Ground (HP2)
10 0.35 BARE 514 Ground (except HP2)
11-12 - - Not Used
Connector Part Information
  • Harness Type: Instrument Panel (STZ or Y91)
  • Harness Type: Instrument Panel Extension (without STZ or Y91)
  • OEM Connector: 15431365
  • Service Connector: 88952886
  • Description: 12-Way F Micro-Pack 100A Series (NA)
Terminal Part Information
  • Terminated Lead: 13575548
  • Release Tool: J-38125-559
  • Diagnostic Test Probe: J-35616-16 (L-GN)
  • Terminal/Tray: 15445905/23
  • Core/Insulation Crimp: J/J
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.