Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSLIFTGATE WINDOW RELEASE SWITCH (E52)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD
Liftgate Window Release Switch (E52)
2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Liftgate Window Release Switch (E52)
Liftgate Window Release Switch (E52)
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 0.35 PK/BK | 6190 | Liftglass/Trunk Exterior Release Signal |
| B | 0.35 BK | 1450 | Ground |
Connector Part Information
|
Terminal Part Information
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.