SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSELECTRONIC POWER STEERING MOTOR CONTROL MODULE X2 (HP2)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Electronic Power Steering Motor Control Module X2 (HP2)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Electronic Power Steering Motor Control Module X2 (HP2)
Fig 1: Electronic Power Steering Motor Control Module X2 (HP2) Connector End View
GM2146536Courtesy of GENERAL MOTORS CORP.
Electronic Power Steering Motor Control Module X2 (HP2)

Pin Wire Circuit Function
1 BK - 42V (-)
2 BK - 42V (+)
3 WH - High Speed GMLAN Serial Data Bus (+)
4 YE - High Speed GMLAN Serial Data Bus (+)
5 GN - High Speed GMLAN Serial Data Bus (-)
6 RD - Battery Positive Voltage - 12V (+)
7 - - Not Used
8 L-BU - High Speed GMLAN Serial Data Bus (-)
9 BK - Serial Data Communication Enable
10-11 - - Not Used
Connector Part Information
  • OEM Connector: Not Available
  • Service Connector: Service by Component Assembly - See Part Catalog
  • Description: 11-Way F (WH with BK case)
Terminal Part Information
  • Terminated Lead: Service by Component Assembly - See Part Catalog
  • Release Tool: Not Available
  • Diagnostic Test Probe: Not Available
  • Terminal/Tray: Not Available
  • Core/Insulation Crimp: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.