SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - A/C COMPRESSOR THROUGH ELECTRONIC POWER STEERING MODULE X1COMPONENT CONNECTOR END VIEWSBODY CONTROL MODULE (BCM) X7
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Body Control Module (BCM) X7

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Body Control Module (BCM) X7
Fig 1: Body Control Module (BCM) X7 Connector End View
GM1664505Courtesy of GENERAL MOTORS CORP.
Body Control Module (BCM) X7

Pin Wire Circuit Function
1 0.35 YE 5704 Endgate Latch Relay Coil Control (E52 without E61)
2 0.35 TN 6188 Lift Glass/Trunk Motor Release Control (E52 without E61, except HP2)
3 0.35 D-GN 5706 Endgate Latch Relay Control (E52 without E61)
4-6 - - Not Used
7 0.35 L-BU 195 Door Lock Control
8 - - Not Used
9 0.35 WH 194 Door Unlock Control
10-17 - - Not Used
18 0.35 L-GN 170 Power Window Master Switch Right Rear Up Signal
19 0.35 PU 169 Power Window Master Switch Left Rear Down Signal
20 - - Not Used
21 0.35 D-BU 1307 Power Window Master Switch Lockout Signal
22-25 - - Not Used
26 0.35 PU 171 Power Window Master Switch Right Rear Down Signal
27 0.35 L-BU/WH 280 Power Window Master Switch Lockout Right Rear Signal
28 0.35 D-GN 168 Power Window Master Switch Left Rear Up Signal
Connector Part Information
  • Harness Type: Body
  • OEM Connector: 15466053
  • Service Connector: 88988806
  • Description: 28-Way F HIT Series (GY)
Terminal Part Information
  • Terminated Lead: 13575870
  • Release Tool: J-38125-12A
  • Diagnostic Test Probe: J-35616-64B (L-BU)
  • Terminal/Tray: SNAC3-A021T-M0.64/20
  • Core/Insulation Crimp: J/J
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.