Accessory AC/DC Power Control Module X1 (HP2)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Accessory AC/DC Power Control Module X1 (HP2)
Fig 1: Accessory AC/DC Power Control Module X1 (HP2) Connector End View
GM1540770Courtesy of GENERAL MOTORS CORP.
Accessory AC/DC Power Control Module X1 (HP2)

Pin Wire Circuit Function
1 - - Not Used
2 0.8 WH 6807 Plug Switch Signal
3 - - Not Used
4 0.8 BK 5683 110 VAC +
5 - - Not Used
6 0.8 D-BU 5685 110 VAC -
Connector Part Information
  • Harness Type: AC Outlet Jumper
  • OEM Connector: 6098-4542
  • Service Connector: 19153185
  • Description: 6-Way F 2.8 Series (OG)
Terminal Part Information
  • Terminal/Tray: Service by Harness - See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.