Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the infrared module.
- Ignition OFF, test for less than 5.0 ohms between the ground circuit terminal 12 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, rear audio ON, test for 10.0-11.0 volts between the supply voltage circuit terminal 4 and ground.
- If less than the specified range, test the voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the rear audio/HVAC module.
- If greater than the specified range, test the voltage supply circuit for a short to voltage. If the circuit tests normal, replace the rear audio/HVAC module.
- If all circuits test normal, replace the infrared module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.