SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSMEMORY SEAT MODULE (MSM) X4 (AN3)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Memory Seat Module (MSM) X4 (AN3)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Memory Seat Module (MSM) X4 (AN3)
Fig 1: Memory Seat Module (MSM) X4 (AN3) Connector End View
GM1664549Courtesy of GENERAL MOTORS CORP.
Memory Seat Module (MSM) X4 (AN3)

Pin Wire Circuit Function
1 1 PU 767 Driver Seat Lumbar Motor Down Control
2 1 TN 768 Driver Seat Lumbar Motor Up Control
3-8 - - Not Used
9 1 PU 5130 Adjustable Pedal Motor Forward Control (JF4)
10 1 OG/BK 5129 Adjustable Pedal Motor Rearward Control (JF4)
11 - - Not Used
12 1 D-BU 611 Driver Seat Lumbar Motor Forward Control
13 1 PK 610 Driver Seat Lumbar Motor Rearward Control
14 1 PK 2480 Ground (without KB6)
1 PU 6196 Ground (KB6)
15 1 L-GN 276 Driver Seat Recline Motor Forward Control
16 1 L-BU 277 Driver Seat Recline Motor Rearward Control
Connector Part Information
  • Harness Type: Driver Seat
  • OEM Connector: 6098-4610
  • Service Connector: Service by Harness - See Part Catalog
  • Description: 16-Way F (GN)
Terminal Part Information
  • Terminated Lead: 13575580
  • Release Tool: J-38125-553
  • Diagnostic Test Probe: J-35616-2A (GY)
  • Terminal/Tray: 8240-0128/22
  • Core/Insulation Crimp: C/A
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.