SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - ELECTRONIC STEERING CONTROL MODULE X2 THROUGH MEMORY SEAT MODULECOMPONENT CONNECTOR END VIEWSLIFTGATE MODULE (LGM) X3 (E61)
2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Liftgate Module (LGM) X3 (E61)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Liftgate Module (LGM) X3 (E61)
Fig 1: Liftgate Module (LGM) X3 (E61) Connector End View
GM1469285Courtesy of GENERAL MOTORS CORP.
Liftgate Module (LGM) X3 (E61)

Pin Wire Circuit Function
1 2 WH 5798 Liftgate Motor Open Control
2 2 BN/WH 5799 Liftgate Motor Close Control
3-4 - - Not Used
5 0.5 D-BU/WH 5796 Liftgate Fully Open Signal
6 0.5 OG 6117 Signal Return
7 - - Not Used
8 0.5 TN/BK 5804 Signal Return
9 0.5 L-BU/WH 5805 Liftgate Position 1 Signal
10 0.5 PU 5806 Liftgate Position 2 Signal
11 0.5 D-GN 5804 Signal Return
12 - - Not Used
13 0.5 TN 5794 Liftgate Engage Control
14 0.5 D-BU 5795 Liftgate Disengage Control
Connector Part Information
  • Harness Type: Liftgate Actuator Assembly
  • OEM Connector: 15466088
  • Service: 19179972
  • Description: 14-Way F 64/2.8 YESC Series (L-GY)
Terminal Part Information
  • Terminal/Tray: Service by Component Assembly - See Part Catalog
  • Core/Insulation Crimp: Not Available
  • Release Tool/Test Probe: Not Available
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.