Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2011TAHOE BASE, 5.3 0, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR SYSTEM, ENTERTAINMENT SYSTEM, AND NAVIGATION SYSTEMREPAIR INSTRUCTIONSAUDIO/VIDEO INTERFACE MODULE REPLACEMENT (AYE)

2011 Chevrolet Tahoe Base, 5.3 0, 4WD

Audio/Video Interface Module Replacement (AYE)

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Audio/Video Interface Module Replacement (AYE)

Fig 1: Audio/Video Interface Module (AYE)

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure
Remove the front floor console side trim - left side. Refer to Front Floor Console Side Trim Front Panel Replacement - Left Side (Cadillac) .

Audio Video Interface Module

Procedure

Remove the foam tape covering the module.
Disconnect the electrical connectors.
Remove the module from the hook and loop fastener on the console.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.