Rear Side Door Lock Replacement

2011 Chevrolet Tahoe Base, 5.3 0, 4WDSECTION Rear Side Door Lock Replacement
Fig 1: Rear Side Door Lock (Crew Cab)
GM1673114Courtesy of GENERAL MOTORS CORP.
Rear Side Door Lock Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
  2. Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
1 Inside Door Handle Cable Retainer Clip
2 Rear Side Door Lock Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .

  1. Release the outside door handle rod from the door lock clip.
  2. The mandatory sequence is 3, 1, 2.

TightenΒ 
10 N.m (89 lb in)
3 Rear Side Door Lock
  1. Disconnect the electrical plug.
  2. Transfer all parts to the new lock.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.