Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011MALIBU LTZ, 2.4 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 616 (OBJECT DETECTION SYSTEM)REPAIR INSTRUCTIONSOBJECT ALARM MODULE REPLACEMENTINSTALLATION PROCEDURE
2011 Chevrolet Malibu LTZ, 2.4 1
Installation Procedure
2011 Chevrolet Malibu LTZ, 2.4 1SECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac Montana SV6, 2007 Chevrolet Uplander, and 2007 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Align the rear object detection module to the vehicle.
- Install the rear object detection module mounting bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Install the electrical connector to the rear object detection module and press in the locking tab.
- Install the rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
- Refer to Control Module References for programming and setup information.
NOTE:
Refer to Fastener Notice
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.