Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011MALIBU LTZ, 2.4 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 408 (ENGINE CONTROLS & FUEL - 3.9L - DTC P0340 TO DTC P2544)DTC P1682TYPICAL SCAN TOOL DATA
2011 Chevrolet Malibu LTZ, 2.4 1
Typical Scan Tool Data
2011 Chevrolet Malibu LTZ, 2.4 1SECTION Typical Scan Tool Data
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
EC Ignition Relay Feedback
| Circuit | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| Operating Conditions: Ignition ON Engine OFF. Powertrain Relay commanded ON | |||
| Ignition 1 voltage | 0 volts | 0 volts | 12 volts |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.