Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011MALIBU LTZ, 2.4 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 273 (AUTOMATIC TRANSAXLE - 4T65-E - INTRODUCTION (2 OF 2))SPECIFICATIONSTRANSMISSION INTERNAL MODE SWITCH LOGIC
2011 Chevrolet Malibu LTZ, 2.4 1
Transmission Internal Mode Switch Logic
2011 Chevrolet Malibu LTZ, 2.4 1SECTION Transmission Internal Mode Switch Logic
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Transmission Internal Mode Switch Logic
| Gear Selector Position | A | B | C | P |
|---|---|---|---|---|
| Park | LOW | HI | HI | LOW |
| Park/Reverse | LOW | LOW | HI | LOW |
| Reverse | LOW | LOW | HI | HI |
| Reverse/Neutral | HI | LOW | HI | HI |
| Neutral | HI | LOW | HI | LOW |
| Neutral/Drive 4 | HI | LOW | LOW | LOW |
| Drive 4 | HI | LOW | LOW | HI |
| Drive 4/Drive 3 | LOW | LOW | LOW | HI |
| Drive 3 | LOW | LOW | LOW | LOW |
| Drive 3/Drive 2 | LOW | HI | LOW | LOW |
| Drive 2 | LOW | HI | LOW | HI |
| Drive 2/Drive 1 | HI | HI | LOW | HI |
| Drive 1 | HI | HI | LOW | LOW |
| Invalid | HI | HI | HI | HI |
| LOW | HI | HI | HI | |
| HI | HI | HI | LOW | |
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.