Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011MALIBU LTZ, 2.4 1REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 260 (COMPUTER/INTEGRATING SYSTEMS)COMPONENT LOCATORCOMPUTER/INTEGRATING SYSTEMS CONNECTOR END VIEWSBODY CONTROL MODULEBODY CONTROL MODULE (BCM) C4
2011 Chevrolet Malibu LTZ, 2.4 1
Body Control Module (BCM) C4
2011 Chevrolet Malibu LTZ, 2.4 1SECTION Body Control Module (BCM) C4
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
Computer/Integrating Systems Connector End Views
Connector Part Information
|
Terminal Part Information
|
Body Control Module (BCM) C4
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1 | RD/YE | 340 | Battery Positive Voltage |
| 2 | TN/PK | 5040 | Battery Positive Voltage (Early Production) |
| TN/OG | 5040 | Battery Positive Voltage (Late Production) | |
| 3 | RD/GN | 440 | Battery Positive Voltage |
| 4 | RD/WH | 1240 | Battery Positive Voltage (Early Production) |
| RD/YE | 1240 | Battery Positive Voltage (Late Production) | |
| 5 | D-BU/WH | 1315 | Right Front Turn Signal Lamp Supply Voltage |
| 6 | - | - | Not Used |
| 7 | YE/PU | 196 | Windshield Wiper Motor Park Switch Signal |
| 8 | - | - | Not Used |
| 9 | BK | 50 | Ground |
| 10 | TN/OG | 3640 | Battery Positive Voltage |
| 11 | D-GN/WH | 1317 | Fog Lamp Relay Control |
| 12-13 | - | - | Not Used |
| 14 | L-GN | 482 | Outside Moisture Sensor Signal 2 |
| 15 | OG/GY | 227 | Windshield Washer Relay Control |
| 16 | TN/WH | 1969 | Headlamp High Beam Relay Control |
| 17 | PK/BK | 109 | Hood Ajar Switch Signal |
| 18 | TN/YE | 481 | Outside Moisture Sensor Signal 1 |
| 19 | D-BU/WH | 5985 | Accessory Wake up Serial Data |
| 20 | D-BU | 6561 | Right Cornering Lamp Relay Control |
| 21 | PK | 1439 | Run/Crank Ignition 1 Voltage |
| 22 | - | - | Not Used |
| 23 | PU | 544 | DRL Relay Control |
| 24 | BN | 6560 | Left Cornering Lamp Relay Control |
| 25 | - | - | Not Used |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.