Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2011MALIBU LTZ, 2.4 1REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDATA COMMUNICATIONS SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT

2011 Chevrolet Malibu LTZ, 2.4 1

Body Control Module Replacement

2011 Chevrolet Malibu LTZ, 2.4 1SECTION Body Control Module Replacement

Fig 1: View Of Body Control Module & Screws

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedure:
Remove the front floor console extension panel - right side. Refer to Front Floor Console Extension Panel Replacement - Right Side .

Body Control Module Bolt Screw (Qty: 3)

CAUTION: Refer to Fastener Caution .

Tighten: 1.5 N.m (13 lb in)

Body Control Module

Procedure

If the scan tool can communicate with the BCM that is being replaced, select BCM copy and flash to copy information from that BCM before removal.
Disconnect the electrical connections.
Refer to Control Module References for programming and set up procedures.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.