Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2011 Chevrolet Malibu LTZ, 2.4 1SECTION Installation Procedure
- Install a NEW air filter assembly.
- Close the air cleaner cover.
- Engage the air cleaner cover latches (1).
- Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
- Install the air cleaner outlet duct to the air cleaner assembly.
- Tighten the air cleaner outlet duct clamp at the air cleaner assembly to 4 N.m (35 lb in).
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.