SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011CHEVY EXPRESS G3500, VAN CARGO EXTENDED, 6.6 LREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL AND STEERING COLUMNREPAIR INSTRUCTIONSUPPER INTERMEDIATE STEERING SHAFT REPLACEMENTINSTALLATION PROCEDURE
2011 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.6 L

Installation Procedure

2011 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.6 LSECTION Installation Procedure
    Fig 1: Upper Shaft To Steering Column Nut Bolt
    GM748880Courtesy of GENERAL MOTORS CORP.
  1. Install the upper intermediate shaft and connect the upper intermediate shaft to the steering column.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the upper intermediate shaft (2) to steering column retaining nut and bolt (1) and tighten to 62 N.m (46 lb ft).
    3. Fig 2: Steering Wheel Lock Tool
    GM333146Courtesy of GENERAL MOTORS CORP.
  3. Install the intermediate shaft bearing. Refer to Intermediate Steering Shaft Bearing Replacement .
  4. Remove the J 42640  steering column anti-rotation pin from the steering column lower access hole.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.