Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011CHEVY EXPRESS G3500, VAN CARGO EXTENDED, 6.6 LREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE PROGRAMMING AND SETUPEBCM REPLACEMENT
2011 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.6 L
EBCM Replacement
2011 Chevrolet Chevy Express G3500, Van Cargo Extended, 6.6 LSECTION EBCM Replacement
If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:
- EBCM programming: Refer to Service Programming System (SPS) .
- With a scan tool perform the yaw rate sensor recalibration and follow the on-screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.