Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2011CHEVY EXPRESS G1500, VAN CARGO, 4.3 XREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC B2610CIRCUIT/SYSTEM TESTING
2011 Chevrolet Chevy Express G1500, Van Cargo, 4.3 X
Circuit/System Testing
2011 Chevrolet Chevy Express G1500, Van Cargo, 4.3 XSECTION Circuit/System Testing
- Incandescent dimming lighting components the vehicle is equipped with.
- Component locations on the incandescent dimming control circuit
- Each component's control and ground circuit terminals
- Ignition OFF, disconnect the harness connector at any component with inoperative incandescent dimming lighting.
- Ignition OFF, scan tool disconnected, interior lamps OFF, doors CLOSED, test for less than 5 Ξ© between the ground circuit and ground.
- If greater than the specified value, test the ground circuit for an open/high resistance.
- Connect a test lamp between the control circuit and ground.
- Command the Incandescent Dimming Control ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
- If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the component with the inoperative incandescent dimming lighting.
NOTE:
Each incandescent dimming lighting component may need to be disconnected to isolate a short to voltage or short to ground. Use the schematic to identify the following:
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.