Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011AVEO LT, 4D SEDAN, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSDIAGNOSTIC INFORMATION AND PROCEDURESKEYLESS ENTRY SYSTEM MALFUNCTIONCIRCUIT/SYSTEM TESTING
2011 Chevrolet Aveo LT, 4D Sedan, Automatic
Circuit/System Testing
2011 Chevrolet Aveo LT, 4D Sedan, AutomaticSECTION Circuit/System Testing
- Verify that the transmitter is the correct transmitter for the vehicle.
- If not the correct transmitter, replace the transmitter.
- Verify the scan tool FOB Programmed parameter for the appropriate transmitter is Yes.
- If not the specified value, program the transmitter. Refer to Remote Control Door Lock Transmitter Programming .
- Place the transmitter on the test pad of the J 43241
and press each transmitter button one at a time. The tester should sound a tone and illuminate a green light with each button press. See Special Tools .
- If one or more buttons does not sound the tone and illuminate the green light, replace the transmitter battery and retest with the J 43241 . If the condition continues after battery replacement, replace the transmitter. See Special Tools .
- Operate the transmitter while observing the scan tool Fob Function parameter for the appropriate transmitter. The parameter should correspond with the function selected on the transmitter.
- If the parameter does not match the function selected on the transmitter, replace the transmitter.
- If all circuits test normal, replace the RCDLR.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.