Circuit/System Verification

2010 Chevrolet RV Cutaway 6.6 LSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Savana and 2010 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Inspect the fuel system for damage or external leaks before proceeding.
  • Verify that adequate fuel is in the fuel tank before proceeding.
  • The fuel pump relay may need to be commanded ON a few times in order to obtain the highest possible fuel pressure.
  • Before proceeding with this test review the User Manual CH 48027-5 for Safety Information and Instructions.
  1. Ignition ON, engine OFF, command the fuel pump relay ON with a scan tool. You should hear the fuel pump turn ON and OFF.
  2. Ignition OFF, all accessories OFF, install a CH-48027Β  . See Special Tools . Refer to Fuel Pressure Gauge Installation and Removal .
  3. Ignition ON, engine OFF, command the fuel pump relay ON with a scan tool. Verify the fuel pressure is between 345-414 kPa (50-60 psi) and does not decrease more than 34 kPa (5 psi) in 1 minute.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.