Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Glow Plug Control Module Bracket Replacement
2010 Chevrolet RV Cutaway 6.6 LSECTION Glow Plug Control Module Bracket Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the glow plug control module. Refer to Glow Plug Control Module Replacement . |
|
| 1 | Glow Plug Control Module Bracket Fastener (Qty: 3)
CAUTION:
Refer to Fastener Caution . Tighten 25 N.m (18 lb ft) |
| 2 | Glow Plug Control Module Bracket Fastener Tighten 10 N.m (89 lb in) |
| 3 | Glow Plug Control Module Bracket Procedure Unclip the electrical wiring harness retainers from the glow plug control module bracket. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.