Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2010 Chevrolet RV Cutaway 6.6 LSECTION Installation Procedure
- Place the bottom edge of the ECM into the bracket lower retainers.
- Push the ECM (4) towards the bracket until the upper edge of the ECM snaps into place.
- Install the ECM mounting bolts (1).
- Connect the ECM electrical connectors (3).
- Install the master cylinder. Refer to Master Cylinder Replacement .
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection And Connection .
- If a NEW ECM was installed, program the ECM. Refer to Control Module References .
- Perform the turbocharger learn procedure. Refer to Turbocharger Learn .
- Perform the crankshaft position reluctor wheel learn procedure. Refer to Crankshaft Position Reluctor Wheel Learn .
CAUTION:
Refer to Fastener Caution .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.