SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU LT, 3.6 7REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 948 (WIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - E29RF THROUGH K33)COMPONENT CONNECTOR END VIEWSK28 HEADLAMP LEVELING CONTROL MODULE X1
2010 Chevrolet Malibu LT, 3.6 7

K28 Headlamp Leveling Control Module X1

2010 Chevrolet Malibu LT, 3.6 7SECTION K28 Headlamp Leveling Control Module X1
WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: K28 Headlamp Leveling Control Module X1 Connector End View
GM1664586Courtesy of GENERAL MOTORS CORP.
K28 Headlamp Leveling Control Module X1

Pin Wire Circuit Function
1 0.35 PK 7528 Local Interconnect Network 6
2 0.35 TN 7529 Local Interconnect Network 7
3 0.35 PK 3203 Right Headlamp Outage Detection Signal
4 - - Not Used
5 0.35 TN 2501 High Speed GMLAN Serial Data Bus -
6 0.35 TN/BK 2500 High Speed GMLAN Serial Data Bus+
7-8 - - Not Used
9 0.35 PK 3204 Left Headlamp Outage Detection Signal
10 0.35 PK 7528 Local Interconnect Network 6
11 0.35 TN 7529 Local Interconnect Network 7
12 - - Not Used
13 0.35 TN 2501 High Speed GMLAN Serial Data Bus -
14 0.35 TN/BK 2500 High Speed GMLAN Serial Data Bus+
15-16 - - Not Used
Connector Part Information 
  • Harness Type: Body
  • OEM Connector: 13546115
  • Service Connector: 89047359
  • Description: 16-Way F Kaizen 0.64 Series (NA)
Terminal Part Information 
  • Terminal/Tray: SAIT-A03T-M064/14
  • Core/Insulation Crimp: P/P
  • Release Tool/Test Probe: J-38125-215A/J-35616-64B (L-BU)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.