Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU LT, 3.6 7REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 378 (WIRING SYSTEMS & POWER MANAGEMENT - COMPONENT LOCATOR - COMPONENT VIEWS AND POWER, GROUND AND INLINE HARNESS CONNECTOR VIEWS)ELECTRICAL CENTER IDENTIFICATION VIEWSFUSE BLOCK - REAR C2
2010 Chevrolet Malibu LT, 3.6 7
Fuse Block - Rear C2
2010 Chevrolet Malibu LT, 3.6 7SECTION Fuse Block - Rear C2
WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Fuse Block - Rear C2 Connector Parts Information
Connector Part Information
|
Terminal Part Information
|
Fuse Block - Rear C2 Connector Terminal Identification
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A1 | - | - | Not Used |
| A2 | BN | 9 | Park Lamp Supply Voltage (Extended Sedan) |
| A3-A12 | - | - | Not Used |
| B1 | BN | 9 | Park Lamp Supply Voltage |
| BN | 9 | Park Lamp Supply Voltage | |
| B2 | - | - | Not Used |
| B3 | L-GN | 24 | Backup Lamp Supply Voltage |
| L-GN | 24 | Backup Lamp Supply Voltage | |
| B4-B12 | - | - | Not Used |
| C1-C2 | - | - | Not Available |
| C3-C8 | - | - | Not Used |
| C9 | D-GN | 19 | Right Rear Stop/Turn Lamp Supply Voltage |
| C10 | - | - | Not Used |
| C11 | YE | 18 | Left Rear Stop/Turn Lamp Supply Voltage |
| C12 | - | - | Not Used |
| D1-D12 | - | - | Not Used |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.