Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU LT, 3.6 7REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 252 (EXTERIOR TRIM)
2010 Chevrolet Malibu LT, 3.6 7
Section 252 (Exterior Trim)
2010 Chevrolet Malibu LT, 3.6 7SECTION Section 252 (Exterior Trim)
WARNING: This page is about a different car, the 2006 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Repair Instructions
- Front Fender Emblem and Nameplate Replacement
- Front Fender Ornament Replacement (3 Hole)
- Front Fender Ornament Replacement (4 Hole)
- Rear Compartment Lid Emblem and Nameplate Replacement
- Radiator Grille Emblem Replacement
- Hood Front Molding Replacement
- Body Side Window Reveal Molding Replacement
- Front Side Door Molding Replacement
- Rear Side Door Molding Replacement
- Rocker Panel Molding Replacement
- Roof Weld Joint Reveal Molding Replacement
- Body Lock Pillar Reveal Molding Replacement
- Rear Compartment Lid Lower Molding Replacement
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.