SYS.OK|MANUAL.DBâ—Ź LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU LT, 3.6 7REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 194 (OBJECT DETECTION SYSTEM)COMPONENT LOCATOROBJECT DETECTION CONNECTORSREAR OBJECT SENSOR CONTROL MODULE
2010 Chevrolet Malibu LT, 3.6 7

Rear Object Sensor Control Module

2010 Chevrolet Malibu LT, 3.6 7SECTION Rear Object Sensor Control Module
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Object Sensor Control Module Connector End View
GM599191Courtesy of GENERAL MOTORS CORP.
Object Detection Connector End Views

Connector Part Information 
  • OEM: 12124957
  • Service: 88987946
  • Description: 26-Way F Amp MODULAR (BK)
Terminal Part Information 
  • Terminal: Not Serviced in Kit
  • Core/Insulation Crimp: N/A
  • Release Tool/Test Probe: N/A
Rear Object Sensor Control Module

Pin Wire Color Circuit No. Function
1 YE 2375 LR Corner Object Sensor Signal
2 OG 2376 LR Middle Object Sensor Signal
3 D-GN 2377 Right Rear Middle Object Sensor Signal
4 PU 2378 RR Corner Object Sensor Signal
5 D-BU 2374 Object Sensor Supply Voltage
6 GY 2379 Object Sensor Low Reference
7-11 - - Not Used
12 BK 350 Ground (Early Production)
BK 850 Ground (Late Production)
13 PK 739 Ignition 1 Voltage
14 GY 2616 Rear Parking Assist Disable Switch Signal
15 L-GN 24 Backup Lamp Supply Voltage
16 L-GN 2525 Rear Parking Assist Diagnostic Input
17 - - Not Used
18 D-GN 389 Vehicle Speed Signal
19-21 - - Not Used
22 L-BU 2380 Rear Parking Assist Chime Signal
23 WH 2370 Telltale Assembly Supply Voltage
24 GY 2373 Red Indicator Control
25 D-BU 2372 Center Amber Indicator Control
26 OG 2371 Left Amber Indicator Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.