Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010IMPALA LT, 3.5 NREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCIRCUIT PROTECTION DEVICES
2010 Chevrolet Impala LT, 3.5 N
Circuit Protection Devices
2010 Chevrolet Impala LT, 3.5 NSECTION Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| Fusible Links (Police) (3 & 6) | Underhood battery stud. See Figure. |
| I/P Fuse Block | Right kick panel. See Figure. |
| Rear Junction Block | Right side of trunk. See Figure. |
| SEO Fuse Block | Left side of dash. See Figure. |
| Terminator Resistor (W/GPS) | Left side of trunk. See Figure. |
| Terminator Resistor (W/O GPS) (5) | Left kick panel. See Figure. |
| Underhood Fuse Block | Right side of engine compartment. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.