Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010HHR LT, 2.4 V, AUTOMATICREPAIR AND DIAGNOSISQUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCIRCUIT PROTECTION DEVICES
2010 Chevrolet HHR LT, 2.4 V, Automatic
Circuit Protection Devices
2010 Chevrolet HHR LT, 2.4 V, AutomaticSECTION Circuit Protection Devices
CIRCUIT PROTECTION DEVICES LOCATION
| Component | Location |
|---|---|
| BCM Fuseholder (3) | In rear compartment of vehicle, near battery. See Figure. |
| Fuse Block - Rear Access Panel (Panel Van) | Right rear of cargo area. See Figure. |
| Fuse Block - Underhood | In engine compartment, next to left strut tower. See Figure. |
| Liftgate Relay Block (Panel Van) | In engine compartment, attached to left wheel well. See Figure. |
| Relay Block (Panel Van) | Left side engine compartment. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.