SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010EQUINOX LTZ, 2.4 W, FWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDATA COMMUNICATION SYSTEMREPAIR INSTRUCTIONSBODY CONTROL MODULE REPLACEMENT
2010 Chevrolet Equinox LTZ, 2.4 W, FWD

Body Control Module Replacement

2010 Chevrolet Equinox LTZ, 2.4 W, FWDSECTION Body Control Module Replacement
Fig 1: Body Control Module
GM2246861Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the drivers side insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Equinox) or Instrument Panel Insulator Panel Replacement - Left Side (Terrain)
  2. Remove the driver knee bolster reinforcement. Refer to Driver Knee Bolster Reinforcement Replacement (Equinox) or Driver Knee Bolster Reinforcement Replacement (Terrain)
1 Body Control Module

Procedure

  1. Disconnect the electrical connectors.
  2. Depress the tab on the bracket and slide the module forward.
  3. Reprogram the module if replaced. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.