Inflatable Restraint Vehicle Rollover Sensor Replacement

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Inflatable Restraint Vehicle Rollover Sensor Replacement
Fig 1: Identifying Inflatable Restraint Vehicle Rollover Sensor
GM1894807Courtesy of GENERAL MOTORS CORP.
Callout Component Name
WARNING: Refer to SIR Warning .

Preliminary Procedure

  1. Disable the SIR. Refer to SIR Disabling and EnablingΒ .
  2. Remove the front floor mat/carpet. Refer to Front Floor Mat/Carpet Replacement .
1 Inflatable Restraint Roll Over Sensor Nuts (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:Β  10 N.m (88 lb in)

2 Inflatable Restraint Roll Over Sensor
Procedure:Β 
Disconnect electrical connectors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.