SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWS SYSTEMREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REPLACEMENTREMOVAL PROCEDURE
2010 Chevrolet Chevy Express G3500, Van Passenger Extended

Removal Procedure

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Removal Procedure
  1. Raise the front door window (1) approximately half way in order to access the nuts (2) that retain the front door window to the sash.
    2. Fig 1: View Of Front Door Window & Nuts
    GM333900Courtesy of GENERAL MOTORS CORP.
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front door rear garnish. Refer to Front Side Door Rear Garnish Molding Replacement .
  4. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  5. Lower the front door window (1).
  6. Remove the inner window sealing strip. Refer to Front Side Door Window Belt Inner Sealing Strip Replacement .
  7. Remove the outer window sealing strip. Refer to Outer Belt Sealing Strip Replacement .
  8. Remove the front run channel from the door. Refer to Front Side Door Window Channel Replacement .
  9. Remove the nuts (2) that retain the front door window (1) to the sash.
  10. Remove the front door window (1) from the door from the outer side of the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.