SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWS SYSTEMREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW MODULE REPLACEMENT
2010 Chevrolet Chevy Express G3500, Van Passenger Extended

Front Side Door Window Module Replacement

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Side Door Window Module Replacement
Fig 1: Identifying Front Side Door Window Module
GM1938494Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Position the front side door window as needed for service.
  2. Remove the front side door trim panel. Refer to Front Side Door Trim Panel Replacement .
  3. Remove the front side door water deflector. Refer to Front Side Door Water Deflector Replacement .
  4. Remove the nuts from the front side door window sash. Refer to Front Side Door Window Replacement .
1 Front Side Door Lock Screw (Qty: 3)
CAUTION: Refer to Fastener Caution .

Procedure

  1. The front side door lock and lock rods stay with the regulator module.
  2. Disconnect the electrical connector, located in the front side door conduit.

Tighten:  10 N.m (89 lb in)
2 Front Side Door Window Regulator Module Rivet (Qty: 5)

Procedure

  1. Remove the center of the rivets in the front side door window regulator module using a center punch.
  2. Drill out the front side door window regulator module rivets, use equivalent rivets when install.
3 Front Side Door Window Regulator Module

Procedure

  1. Slide the front side door window regulator lower roller out of the lower sash by sliding it forward with the module.
  2. Lift upward and pull rearward to release the front side door window regulator module from the door.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.