Installation Procedure

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
  1. Position the window to the full up position.
  2. Fig 1: Installing Spring Clip To Door Window Regulator Handle
    GM748354Courtesy of GENERAL MOTORS CORP.
  3. Install the spring clip (2) to the door window regulator handle (1).
  4. Install the door window regulator handle (1) bearing plate.
  5. Position the door window regulator (1) handle to the regulator.
  6. Install the door window regulator handle (1), press in until fully seated.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.