Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESFRONT DRIVE AXLE
2010 Chevrolet Chevy Express G3500, Van Passenger Extended
Front Drive Axle
2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Front Drive Axle
- Specifications
- Component Locator
- Diagnostic Information and Procedures
- Repair Instructions
- Front Axle Lubricant Replacement
- Vent Hose Replacement
- Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement
- Front Drive Axle Inner Shaft Seal and Inner Shaft Bearing Replacement
- Front Differential Drive Pinion Gear Yoke Replacement
- Differential Carrier Assembly Bushing Replacement (Inner Axle Shaft Housing)
- Differential Carrier Assembly Bushing Replacement (Differential Carrier)
- Differential Carrier Assembly Replacement
- Front Axle Lubricant Level Inspection
- Differential Carrier Assembly Disassemble
- Front Differential Case Disassemble
- Differential Case Bearings Inspection
- Differential Case and Gears Inspection
- Pinion and Ring Gear Inspection
- Thrust Washers, Shims, and Adjuster Sleeves Inspection
- Front Differential Case Assemble
- Front Differential Drive Pinion Gear Bearing Cup Installation
- Pinion Depth Adjustment
- Differential Carrier Assembly Assemble
- Backlash Inspection and Adjustment
- Differential Carrier Assembly Final Assembly
- Gear Tooth Contact Pattern Inspection
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.