Installation Procedure

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Installation Procedure
  1. Install the stationary window into the opening. Refer to Adhesive Installation of Stationary WindowsΒ .
  2. Install the defroster grille. Refer to Instrument Panel Upper Trim Pad Replacement .
  3. Install the windshield interior garnish moldings. Refer to Upper Pillar Garnish Molding Replacement .
  4. Install the inside rearview mirror. Refer to Inside Rearview Mirror Replacement .
  5. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
  6. Install the windshield frame filler panel. Refer to Upper Front Fender Filler Panel Replacement .
  7. Close the hood
  8. Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
  9. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.