SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEMREPAIR INSTRUCTIONSTAIL LAMP REPLACEMENT
2010 Chevrolet Chevy Express G3500, Van Passenger Extended

Tail Lamp Replacement

2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION Tail Lamp Replacement
Fig 1: View Of Tail Lamp
GM1892830Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
Remove the back body side opening applique. Refer to Back Body Opening Side Applique and Tail Lamp Replacement .
1 Tail Lamp Nut (Qty: 3)
CAUTION: Refer to Fastener Caution .

Tighten:  5 N.m (44 lb in)
2 Tail Lamp Electrical Connector

Procedure

  1. Pull the lamp assembly rearward.
  2. Release the electrical harness rubber grommet.
  3. Disconnect the electrical connector from the rearward lamp harness.
3 Tail Lamp Assembly
Tip:  Remove the bulb sockets and service the bulbs as needed.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.