Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CHEVY EXPRESS G3500, VAN PASSENGER EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUP (W/RPO LMM)ECM REPROGRAMMING
2010 Chevrolet Chevy Express G3500, Van Passenger Extended
ECM Reprogramming
2010 Chevrolet Chevy Express G3500, Van Passenger ExtendedSECTION ECM Reprogramming
- Record Fuel Filter Life.
- Enable ECM Reprogramming - Refer to Service Programming System (SPS) .
- Reset Fuel Filter Life to the recorded value.
- Start and idle vehicle.
- Using the scan tool, perform the Turbocharger Learn Procedure. Refer to Turbocharger Learn .
- Perform a Diesel Particulate Filter (DPF) Regeneration Enable .
- If necessary, perform the following:
- Theft Deterrent - Refer to Theft Deterrent Module Programming and Setup .
- The Fuel Injector Flow Rate Programming - Refer to Fuel Injector Flow Rate Programming .
- Engine Oil Life Remaining-Use scan tool to reset Engine Oil Life.
IMPORTANT:
It is necessary to record Fuel Filter Life before reprogramming. The ECM reprogramming procedure will reset Fuel Filter Life to zero.
IMPORTANT:
Clear any DTCs that may have set after completing the programming procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.