Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CAMARO V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAUL133. EXHAUST MANIFOLD INSTALLATION - LEFT SIDE
2010 Chevrolet Camaro V6-3.6L
133. Exhaust Manifold Installation - Left Side
2010 Chevrolet Camaro V6-3.6LSECTION 133. Exhaust Manifold Installation - Left Side
Exhaust Manifold Installation - Left Side
1. Position a NEW exhaust manifold gasket onto the left exhaust manifold.
2. Install the exhaust manifold bolts into the left exhaust manifold.
3. Place the left exhaust manifold, exhaust manifold gasket and bolts as an assembly in position on the left cylinder head.
Caution: Refer to Fastener Caution (Fastener Caution).
4. Install the exhaust manifold bolts into the left cylinder head and tighten to 20 Nm (15 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.