Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CAMARO V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE AND REPAIROVERHAUL111. TIMING CHAIN IDLER SPROCKET INSTALLATION - LEFT SIDE
2010 Chevrolet Camaro V6-3.6L
111. Timing Chain Idler Sprocket Installation - Left Side
2010 Chevrolet Camaro V6-3.6LSECTION 111. Timing Chain Idler Sprocket Installation - Left Side
Timing Chain Idler Sprocket Installation - Left Side
1. Ensure that the left camshaft intermediate drive chain idler (2) is being installed. The recessed hub (3) and the larger sprocket of the left camshaft intermediate drive chain idler is installed outward. The raised hub and the smaller sprocket of the left camshaft intermediate drive chain idler is installed towards the block.
2. Place the left camshaft intermediate drive chain idler to the cylinder block.
Caution: Refer to Fastener Caution (Fastener Caution).
3. Install the camshaft intermediate drive chain idler bolt and tighten to 58 Nm (43 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.