SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010AVEO LT, 4D HATCHBACK, STANDARDREPAIR AND DIAGNOSISSTEERINGSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSTURN SIGNAL MULTIFUNCTION SWITCH REPLACEMENTINSTALLATION PROCEDURE
2010 Chevrolet Aveo LT, 4D Hatchback, Standard

Installation Procedure

2010 Chevrolet Aveo LT, 4D Hatchback, StandardSECTION Installation Procedure
    Fig 1: Turn Signal Switch Tabs & Electrical Connectors
    GM1715990Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors (1, 4) to the turn signal switch.
  2. Install the turn signal switch into the switch housing.
    3. Fig 2: Steering Column Panels & Screws
    GM1715979Courtesy of GENERAL MOTORS CORP.
  3. Install the upper steering column cover panel (1) and the lower steering column cover panel (5).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the lower steering column cover panel screws (6, 7, 8) and tighten to 3 N.m (27 lb in).
  5. Turn the steering wheel in order to access the upper steering column cover panel screw holes. Install the upper steering column cover panel screws (3, 4) and tighten to 3 N.m (27 lb in).
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.